dam i thought that could be it...... i hope when i fix the wodes connection it will fix it .....i hope

cant it has to be trying to share a 5v 3 ways

the 5v is from the power pins on the board its being shared with wii drive power and the wode lcd power.....Would sharing the pins cause a problem? i can move it too the mega drive

ill de-solder it again .......but why is my audio scratchy? i had to use the audio fix but it is very low i have to crank it up to hear it and it sounds distroted when it hits a high notes

I got my game cube to load from WODE but its very touchy......it works when it chooses other wise the gamecube does the "Error has cocured please consult the manual." any ideas? my wode is up to the latest version..... the wiring is correct (i think). I loaded the "configure" iso...

thats what i thought but i didnt think it was the correct way to do it.....another question can you solder resits at home. (painting the board green)

hey quick question.... the holes on the pcb that i used to connect traces from the front to the back. how do i go about doing it? Do i fill the hole with solder? or is there something I'm supposed to use?

ok ill scrap the mini thank you

28 pin Dip = 32 pin Dip ------------------------ 1 = 29 2 = 30 3 = 31 4 = 32 5 = 1 6 = 2 7 = 4 8 = 3 9 = 7 10 = 8 11 = 9 12 = 10 13 = 11 14 = 12 15 = 13 16 = 14 17 = 15 18 = 16 19 = 17 20 = 18 21 = 20 22 = 21 23 = 23 24 = 24 25 = 25 26 = 26 27 = 27 28 = 28 ------------------------- Not conected pins...

why did you move the pin from the isp to the R1 pin? And i thought i needed the isp to program it with the xeno firmware? and the mini is my assumption of the pin outs using the date sheet for the two of them by matching signals... the mini require parts a tad difficult to obtain so it may not be ma...

ok my apologies here the fixed pics...

I am very new with PCB manufacturing but, I wanted to learn and creating a mod chip seems to be a good place to start.... remember i am very new to this so and incite would be appreciated. I fallowed the guide from http://www.gc-forever.com/wiki/index.php?title=XenoGC_Clone#Building_the_Board XENOGC...

so make the cabling between the adapter and the gamecube shorter? i never thought of it. ill give it a shot

ok i switched it and adjust my cables still wont read iso and with shorter cable the wode wont read sd card

the long cable came with the wode and everytime i switch with a new one the wodes lcd wont come back on. but ill try it

http://www.youtube.com/watch?v=CGZ7S6QuSIE
poof there :/

its blake displaying the "?" its say insert a gamecube disc and when i hit the switch to close the drive it just says reading disc. nada happens

but i just re did the wiring, Is there a better guide i could use?

The wode screen come on and loads .iso's and i can eject them using the the wii eject and i can use the gc eject making the gamecube say "reading disc." But the wode says "0 reads" and "0 kbs" and just sits there.

I have solder the connection 3 times over and i get no response from GameCube each time. The both eject buttons works but no attempt to read the iso from game cube. I fallowed the guide from: http://forums.modretro.com/viewtopic.php?f=36&t=6003 : Am i supposed to patch the wode or something? I a...