Search found 5 matches

by gckrz
Mon Apr 20, 2020 11:15 am
Forum: Hardware / Modding
Topic: Hi, about Serial port 2 USB for Swiss, any chance?
Replies: 104
Views: 21603

Re: Hi, about Serial port 2 USB for Swiss, any chance?

Just do not use outdated SWISS releases, always keep up to date so you'll get the better from it. :roll: 775-1 was the latest release at the time I received the board and burnt the disk :? Pin assignment is quite straightforward: SP-SD VCC-VCC GND-GND CS-CS CLK-CLK MOSI-MOSI MISO-MISO Beware, if MI...
by gckrz
Sun Apr 19, 2020 7:53 pm
Forum: Hardware / Modding
Topic: Hi, about Serial port 2 USB for Swiss, any chance?
Replies: 104
Views: 21603

Re: Hi, about Serial port 2 USB for Swiss, any chance?

Thanks, I will check whether the traces are same.
Should I take away SD-card slot and inspect beneath?
Also, what is pin assignment?
by gckrz
Sun Apr 19, 2020 3:01 pm
Forum: Hardware / Modding
Topic: Hi, about Serial port 2 USB for Swiss, any chance?
Replies: 104
Views: 21603

Re: Hi, about Serial port 2 USB for Swiss, any chance?

The Gamecube has XenoGC in it. I am booting from a DVD-R with swiss-gc v0.4r775-1. I can execute the .dol from the 512 mb sd-card in the SP2SD. I did not put any iso-s on it, because they do not fit. The 2 Gb card which is detected just shows up in the selection of sources. When I select it, it disa...
by gckrz
Sat Apr 18, 2020 7:06 pm
Forum: Hardware / Modding
Topic: Hi, about Serial port 2 USB for Swiss, any chance?
Replies: 104
Views: 21603

Re: Hi, about Serial port 2 USB for Swiss, any chance?

Here it is. The original capacitor was measured to be 4.5 uF, I replaced that with two 11 uF in parallel which gives 22 uF... Still, I can read only 512 SD cards, the 2 Gb is detected (allows to select it at start) but won't read anything, included files. The SD cards are formatted FAT32, primary pa...
by gckrz
Mon Apr 13, 2020 8:22 pm
Forum: Hardware / Modding
Topic: Hi, about Serial port 2 USB for Swiss, any chance?
Replies: 104
Views: 21603

Re: Hi, about Serial port 2 USB for Swiss, any chance?

Hello, and excuse me for possibly hijacking this thread. Thank you first of all for everybody involved, who made SP2SD possible, software and hardware wise. I am also having touble with a sp2sd homemade adaptor. Without finding a readymade one (at the time they were all sold-out), I asked my friend ...