DragonBoy GCVideo is not ready yet which is why your order has not shipped. You can already see your order was updated to include the WASP months ago. If you wanted me to ship em separately then i didnt see the message or it slipped my mind. I can still ship the wasp alone and GCVideo later on or yo...

nothing is wrong with your order.
You email is being held in unread status. This is an active reminder else if i mark it as read I will forget the specifics of your request.
Dont worry about your order.

emu_kidid wrote:I'm gone for a week and liquitt and gc-Linux come back to life!

maybe you should leave more often, things seem to always happen when "you're" not around

here is some feedback to consider on how to re-evaluate to possibly come up with something better, a little more safer, and more secure. the biggest problem with connector is the pins. there is no protection for them at all in this quickly drawn pic you can see whats happening here in the official c...

i always wondered who was gonna be the first to try to release the PCB sandwich solution
...you know, a proper replacement connector would be much better in the long run

necroquote strikes again

12v is fed to the amp.


On some rare occasions the powerboard does something funky to cause an issue with 12v.
Try another powerboard.
If that doesnt work, check if the amp is getting 12v

just to clarify and expand on what streetwalker posted: removing the digital port is optional. - If you want to remove the digital port and connect a drop in replacement connector, you can - if you want to not bother removing the digital port, then you can install a new connector on the left side of...

have you updated wode to Firmware 2.8A?

I think 2.2 might require the IR sensor to be connected else it will fail to initialize correctly. I tested without the IR sensor and ran into the same issues mentioned above of not being able to call the OSD and displaying the checkerboard video.. also the resolution popup box fails to display duri...

check your region configuration on wasp

http://www.gc-forever.com/wiki/index.ph ... ASP_Fusion

pictures of your setup

zeldaxpro wrote: I have finally fixed the bridge on the IC

bridge on the IC????

you need to flash swiss

blubb wrote:(did everything according to the Wiikey Fusion update guide)

can you post a link to the guide you used?
seems like it needs to be updated


also look in the swiss nightly thread and find the swiss recovery iso....this is what you should be using to flash your firmware...not 1.5 firmware...

why are you using 1.5 firmware?

lid switch is not suppose to be connected to GND
properly connect lid pin on wode to GC lid pad

before you solder the board you might want to take some time to find a way to mount it so its not permanently sticking out... you will be asking for problems in the long run by connecting this board as designed before you flash try to establish communication with the chip....open up impact which is ...

first you will need to connect your dvd drive inline to the wasp DVD side connector with the wasp host side connected to the mainboard...they cannot both be connected to the motherboard at the same time second, if you flash wasp with swiss, then swiss can unlock your DVD drive... no need for a xeno ...

what version of swiss are you using?

People validating that the NTSC-U GBP startup disc boots to the missing Gameboy Player message isn't a true test. I observed that error message too, before recently buying what I assume to be a PAL Gameboy Player unit. However the NTSC-U gcm rip of the startup disc just freezes on a green screen af...

connecting to the dataline would most likely show a blinking LED as data is transmitted and the controller port is usually transmitting data even if no controller is plugged. If you wanted a solid LED only when the controller is plugged in you will have to get creative with some sort of micro switch...

what version is the firmware?

take a look in the "about" menu
there was an option added in later firmware to enable "enhanced DVI"
this option allows audio over hdmi connection