wasnt there some issue with FTDI drivers bricking chips?

dont worry to much about the compatibility list since its not really up to date and compatibility results vary from setup to setup xeno will not be required since swiss can patch the drive. Any previous posts I wrote about needing a xeno are out of date since there was a bug discovered with swiss th...

the wii dvd drive can be used as an optical drive replacement and there are even "drive replacement" modchips

not to complicate this but just want to add there were also many versions of the same title and also different regional releases...

@niuus
this release is specifically for GC performance testing due to previous reports of slowdowns...

wouldnt it be better to make a database of xeno based MD5 and use that file instead of the redump file?


of course the best method is just turn off xeno

there is no audio streaming issue with MEGAdrive V3
it passes all the commands thru

new version released, please confirm if freezing issues are gone. They seem to be resolved now on my end using SDGecko but i only tested a couple of titles. Bug 1: I place NeoCD.bin as wkf/bios/NeoCD.bin and games as wkf/neocd/roms/mygames, and the emulator tells no BIOS found. If I copy NeoCD.bin t...

video proof of the same issue back in 2014

sounds like its not connected properly...try reseating the ffc cable and make sure the flaps on the connector actually close down all the way

angry birds

orange pikachu n64 please

soul calibur has issues loading from SD Gecko, otherwise it works perfect with swiss thru WASP

swiss r299 ??

ive finally had some time to complete the case designs that have been holding back release of this project.. ill post a final pic in a day or two after i get a few different color options done... im also going to to have to flash all the existing boards with v2 firmware then ill update the webstore ...

if you are not getting continuity between top side and bottom side there there is no connection. since your board is lifted you will need to either desolder the entire board and try to reposition flat or cut some pins from the drive connector you pulled off and use the pins to push thru to the other...

im not use to scrolling down this much...
i think i need a trackball now!!

if you already have swiss autoboot installed then you can update to latest with the FZN only from WKF/WASP slot
just load the fzn and swiss will perform the update for you...do not reboot or poweroff system until its complete..

where is pin29 going?

you will need to wait and wait and wait to see if someone sells their Viper....

provide a pic, video doesnt show enough info
also, swiss cannot read WBFS

do you have an SD card in the wasp slot?

installation of pluto is exactly as described on github...
pluto fitment within the GC is another story

andre104623 wrote:Just to let everyone know i have abandon the shuriken v2 for the v3 version. I was having issues with the v2 pcb the silkscreen was off causing the components to be grounded so im going to give the v3 a go

silkscreen??
....dont you mean the soldermask