GameCube laser keeps clicking and doesn't read the discs

All your console related questions and answers :)
ohmiomy
Posts: 19
Joined: Thu Dec 21, 2017 2:00 am

Re: GameCube laser keeps clicking and doesn't read the discs

Post by ohmiomy » Wed Jul 11, 2018 9:17 pm

I tried 120 and 50 ohm, still not reading the disc
ohmiomy
Posts: 19
Joined: Thu Dec 21, 2017 2:00 am

Re: GameCube laser keeps clicking and doesn't read the discs

Post by ohmiomy » Fri Jul 13, 2018 1:00 am

I tried to turn on the console pressing the start button with an original game. The screen of Xeno GC appeared, but the disc stopped spinning and the screen froze. The chip seems to be installed correctly and working, but something in gamecube is preventing it to perform its function
User avatar
Streetwalker
Posts: 1602
Joined: Mon Dec 30, 2013 7:50 am
Location: Israel

Re: GameCube laser keeps clicking and doesn't read the discs

Post by Streetwalker » Fri Jul 13, 2018 7:20 am

It's just your drive/laser that's bad.
ohmiomy
Posts: 19
Joined: Thu Dec 21, 2017 2:00 am

Re: GameCube laser keeps clicking and doesn't read the discs

Post by ohmiomy » Tue Aug 28, 2018 2:29 am

I bought a new cube and a new laser. I changed the laser and soldered the xeno chip on the new cube. It reads the original discs instantly, but it keeps trying to read the burned discs without success. I started the cube pressing the start button and the Xeno page loaded and worked perfectly. I tried with 180 ohms. What do I do? The chip is working, but it can't read burned discs.
User avatar
emu_kidid
Site Admin
Posts: 4350
Joined: Mon Mar 29, 2010 10:06 am
Location: Australia
Contact:

Re: GameCube laser keeps clicking and doesn't read the discs

Post by emu_kidid » Sat Sep 15, 2018 12:19 pm

ohmiomy wrote:
Tue Aug 28, 2018 2:29 am
I bought a new cube and a new laser. I changed the laser and soldered the xeno chip on the new cube. It reads the original discs instantly, but it keeps trying to read the burned discs without success. I started the cube pressing the start button and the Xeno page loaded and worked perfectly. I tried with 180 ohms. What do I do? The chip is working, but it can't read burned discs.
Have you successfully tried those burned discs anywhere else? It sounds like either they're burned incorrectly or the discs are unreadable.
Image
Post Reply