Page 1 of 1

Flashing swiss to qoob pro chip

Posted: Wed May 27, 2020 9:01 am
by nigelp12345
Hey,

I've had a gc for a while now with a qoob pro switch.
I've never tampered with flashing it before nor do I know how to do it.

Came across sd2sp2 and seen people were flashing something called swiss to the bios or having to qoob pro bios boot swiss from sd.

I'm also hearing I need a usb programmer to flash qoob pro which I dont have but my gc has a small USB on the back attached to the chip. Couldnt I just plug a USB cable into it to the PC and flash it that way?

I want my GC to have it all just need some guidance.

Re: Flashing swiss to qoob pro chip

Posted: Thu Jun 04, 2020 3:01 am
by emu_kidid
Show pictures of the USB and how it's connected to the Qoob PRO. Some full sized disc shells added a USB-A port on the back that could connect to the Qoob internally, if it's set up properly you should be able to use it to flash Swiss onto the Qoob.

Re: Flashing swiss to qoob pro chip

Posted: Sun Jul 26, 2020 3:37 pm
by Melbatoast1985
hey i have a Qoob pro with the mini usb and the full sized usb and i'm also kind of looking for a guide on how to flash Swiss to the memory of the qoob pro. Is it just as simple as getting the flashing program and replacing the 1.3c firmware?