Page 1 of 1
GameCube Service disc iso in Swiss
Posted: Mon May 04, 2020 12:42 am
by collinlg9
So I’m trying to load the GameCube service disc Iso on Swiss using SD2SP2. I am unable to get it to boot, and I know that my GameCube was from before 2003. Anyone else tried this? Just wanting to see if it works on Swiss.
Re: GameCube Service disc iso in Swiss
Posted: Mon May 04, 2020 10:23 pm
by Diego borella
where do you want to go friend?
far as I know, emu_kidid has a disc like that ...
of your experience,
maybe he can tell us something ...
Re: GameCube Service disc iso in Swiss
Posted: Mon May 04, 2020 11:20 pm
by emu_kidid
Yeah, it's not compatible at the moment as far as I know. It's not even compatible when using the real disc on certain revisions of GameCube (maybe the IPL hates it).
Re: GameCube Service disc iso in Swiss
Posted: Mon May 04, 2020 11:40 pm
by Diego borella
what if I run a Swiss ISO, by the Swiss himself?
Re: GameCube Service disc iso in Swiss
Posted: Tue May 05, 2020 5:53 am
by Papy.G
Does the real disc have an utility to finetune the Laser cell position?
It would have been useful for all those GCs stuck with unadjusted fresh cell.
Re: GameCube Service disc iso in Swiss
Posted: Thu May 14, 2020 6:52 pm
by Diego borella
even using ipl_boot.
411 patches are counted but it doesn't work on my
Dol 001
assistance disk
411 patches #
Re: GameCube Service disc iso in Swiss
Posted: Fri May 15, 2020 10:03 am
by Papy.G
As long as Hardware diagnosis programs go, you need to run them relying on the lower level hardware access possible, so don't expect to run it off an SD card from an SDGecko, it is pointless.
You may as well try to launch it at least off a burnt disc from SWISS, it is the closest to the genuine targetted use you can go unless you have the original disc.