Page 1 of 1
WODE not being read
Posted: Wed Jul 20, 2016 11:24 am
by vinzanity
Guys I used a breakout board to install a wode on my Gamecube. I wired a switch for the eject and grounded the lidswitch. I tool 3.3 v from the regulator but for testing purposes, I took the 5v from a usb connection (Portable DVD player). My problem is that the reads are 0 so it doesn't seem like the mounted ISO is being read by the unit. Also the second LED is always blue instead of blinking. I hope someone can assist me in finding what is wrong so I can finally close this Gamecube up.
Re: WODE not being read
Posted: Wed Jul 20, 2016 12:36 pm
by megalomaniac
lid switch is not suppose to be connected to GND
properly connect lid pin on wode to GC lid pad
Re: WODE not being read
Posted: Wed Jul 20, 2016 1:08 pm
by vinzanity
Oops. Thanks for the info mega. I just checked and i didn't connect it to GND, only the eject button was. Anything else i can look at? Why does the blue led stay still instead of blinking?
Re: WODE not being read
Posted: Thu Jul 21, 2016 1:49 am
by vinzanity
Just upgraded the firmware from 1.28 to 2.0. Problem fixed!