Page 1 of 1
Need Power Rail From Uncut Mobo?
Posted: Fri Jun 30, 2017 4:32 pm
by officialfbomb
Can someone please mark out on a photo where i can safely pull both 12 and 5 volts from the gamecube mobo safely? I don't plan to make a portable or anything like that, but i need to tap into those volts for a hot swap vehicle project. Thanks!
Re: Need Power Rail From Uncut Mobo?
Posted: Fri Jun 30, 2017 5:01 pm
by novenary
YAGCD has a
pinout of the power board connector, see the
trimming guide for points you can tap into on rev C.
Re: Need Power Rail From Uncut Mobo?
Posted: Fri Jun 30, 2017 5:11 pm
by officialfbomb
Ahh that should work. I already have my cube apart for repairs so i will see if that will suit my needs. Thanks.