Xeno Pinout Dol-101

Portables, case replacements, mods etc, all in here!
Post Reply
RainMaker
Posts: 2
Joined: Sat Mar 02, 2019 6:31 am

Xeno Pinout Dol-101

Post by RainMaker » Sat Mar 02, 2019 6:39 am

Hey,
Was going to make a Xeno chip tomorrow and mod my new cube, but found out its the DOL-101.
Cannot find any pinout, or tutorials for where to solder to.

Can someone help me out? I was going to remove the heatsink, but don't want to waste thermal paste unless I know I can find out which pads or pins to solder to.
Even which pins and which chip would greatly help.

Thanks
User avatar
Srandista
Posts: 18
Joined: Thu Jan 24, 2019 2:15 pm
Location: Czech Republic

Re: Xeno Pinout Dol-101

Post by Srandista » Sat Mar 02, 2019 8:24 am

Why would you be removing heat-sink, when XenoGC is soldered to DVD-ROM's PCB, which is separated from mainboard PCB?
RainMaker
Posts: 2
Joined: Sat Mar 02, 2019 6:31 am

Re: Xeno Pinout Dol-101

Post by RainMaker » Sun Mar 03, 2019 6:27 am

I didnt want to (and I didnt), but I was looking for the same caps I saw in other peoples images and I had assumed they put it on the other side of the PCB.
Nothing I read said you put it on DVD drive PCB, guess I'll take another look. Still would be handy to have a proper pinout or schematic.

I had read that the DOL-101 got rid of a PCB that used to mount on the main board, I was thinking that to fit the components on the board they may have had to move some components to the other side.
Again, just lack of info on the DOL-101.

Edit: Thanks man found it right away.. Guess I was skipped through it all too fast, and assumed it was the version.
Post Reply