Minimal ipl boot Viper GC

Portables, case replacements, mods etc, all in here!
brunops3
Posts: 48
Joined: Mon Feb 06, 2012 5:24 pm

Re: Minimal ipl boot Viper GC

Post by brunops3 » Mon May 18, 2020 6:03 pm

Hi. I have a few questions:

1) Is it possible to use Viper GC (not Extreme) without the Gamecube optical drive (using iplboot as a replacement BIOS on the Viper GC)?

2) If yes, is the instalation of the modchip on Gamecube the same (4 wires to solder and a solder bridge)?

3) What about the two connectors of the lid sensor switch on Viper GC modchip? Just leave them disconnected or do I need to bridge it to simulate the lid always closed?

4) Does the latest revision of iplboot (which boots from SD2SP2) support SDHD/SDXC or just SDSC (2GB or less)?


Thank you.
User avatar
Extrems
Posts: 973
Joined: Tue Aug 17, 2010 10:40 pm
Location: Québec, Canada
Contact:

Re: Minimal ipl boot Viper GC

Post by Extrems » Mon May 18, 2020 6:15 pm

brunops3 wrote:
Mon May 18, 2020 6:03 pm
4) Does the latest revision of iplboot (which boots from SD2SP2) support SDHD/SDXC or just SDSC (2GB or less)?
All homebrew released since 2009 support SDHC/XC. Additionally, iplboot is one of the few things that support exFAT.
brunops3
Posts: 48
Joined: Mon Feb 06, 2012 5:24 pm

Re: Minimal ipl boot Viper GC

Post by brunops3 » Tue May 19, 2020 12:20 am

Extrems wrote:
Mon May 18, 2020 6:15 pm
brunops3 wrote:
Mon May 18, 2020 6:03 pm
4) Does the latest revision of iplboot (which boots from SD2SP2) support SDHD/SDXC or just SDSC (2GB or less)?
All homebrew released since 2009 support SDHC/XC. Additionally, iplboot is one of the few things that support exFAT.
Thx
Lugus
Posts: 2
Joined: Wed Aug 16, 2017 2:50 am

Re: Minimal ipl boot Viper GC

Post by Lugus » Sat Jul 11, 2020 5:43 am

ledu205 wrote:
Mon Jan 13, 2020 6:53 pm
https://uptobox.com/rtsi8kowj7mb iplboot-master.dol
https://uptobox.com/k93bhaeeozbw iplboot-master.vgc

Caution not tested for the moment

Edit : try with dolphin it seems to work
Can you compile/upload the .gcb file too?

I gave up trying to compile this. Too complex to setup.
Post Reply