Pluto 2x Install issues.....

Portables, case replacements, mods etc, all in here!
Post Reply
XpertXP
Posts: 26
Joined: Tue Mar 27, 2018 4:19 pm

Pluto 2x Install issues.....

Post by XpertXP » Mon Oct 17, 2022 8:22 pm

Hi all,

Been installing these boards for a little while now and these new boards do not require the 100ohm resistor. I have not had any luck getting these boards to work properly. The power light on the Pluto 2x flashes green as it should when wired correctly, but the video output will come on for about a minute or so and then just go out.
Im have looked over all my solder connections with a microscope and everything looks fine.

Anyone familiar with this happening or know what could be causing this? Or where I can even start to troubleshoot here.

Also to note, when I bridge the solder point on the Pluto 2x that says HDMi VCC is when I am able to get video output for about a minute or so before it will flicker and then stop doing video output. Without that point bridged I get nothing to display.

Thanks for any help here.
Post Reply