Page 1 of 1
A model of the shell for 3D printing?
Posted: Fri Apr 13, 2018 10:27 am
by Mr_Mary
Does anyone have a 3D model of a Gamecube shell, preferably modded for regular DVD?
Because if no one sells modded shells anymore, why not print one yourself?
Re: A model of the shell for 3D printing?
Posted: Fri Apr 13, 2018 9:20 pm
by novenary
I've never seen one around here, but it shouldn't be too hard to make one.
Re: A model of the shell for 3D printing?
Posted: Tue Apr 24, 2018 10:16 am
by liquitt
who has the right equipment to scan one? would be willing to donate an xecuter case for that purpose.
Re: A model of the shell for 3D printing?
Posted: Fri Apr 27, 2018 5:44 am
by xx77Chris77xx
I was thinking the same thing a while ago. Tempted to try to draw up a cad model. Not very experienced so it would take a while but it could happen. I don't think 3D scanning would work very well for this purpose though. I think I will go for it but it wont be done for a few months since I am still in school.