Page 1 of 1

Saving Swiss settings help

Posted: Fri Aug 28, 2020 9:15 pm
by Just Joe
Hello all. Thank you in advance for your help.

I recently installed the GC loader PNP. Swiss is up and running. I have an SD2SP2 installed as well and selected as the settings save location. When I go to save my Swiss settings, both general and game specific I get the “failed to save” message. The SD card in the SD2SP2 is formatted to FAT32 but other than that I did nothing else to that card, not sure if I needed to. If it matters my GameCube is Japanese region.

Again thank you for any advice you can provide.

Re: Saving Swiss settings help

Posted: Fri Aug 28, 2020 10:21 pm
by Just Joe
I tried a couple of other sd cards and found one that worked. The problem must have been caused by faulty or incompatible card.