SWIIS IGR Video Settings
Posted: Fri Dec 23, 2022 3:46 pm
Hi,
I have a NTCS Gamecube with a GC Loader PNP and a SD2SP2 installed, and everything works fine. I recently picked up a PAL Gamecube so I could get RGB output via scart, so I moved everything over the "new" Gamecube. I am able to configure SWISS (using the PAL iso) so that I get 480i output, which is what I want, as I'm running on a TV that supports up to 480i.
The issue I'm having is that when using the In Game Reset (IGR.dol on the SD2SP2) when I reset back to SWISS (R+Z+B+DOWN or Z+A+Start) it always resets back to 50hz and doesn't seem to honor/load the settings I configured. If I power cycle the Gamecube, SWISS loads the settings as you would expect.
I believe the only two video related changes I made where to set "SWISS Video Mode" to 480i and "Force Video" to 480i
I'm running SWISS version 1318. I don't know if there is a newer IGR, but the one I have is probably a couple years old.
If anyone has any suggestions, please let me know!
Cheers!
I have a NTCS Gamecube with a GC Loader PNP and a SD2SP2 installed, and everything works fine. I recently picked up a PAL Gamecube so I could get RGB output via scart, so I moved everything over the "new" Gamecube. I am able to configure SWISS (using the PAL iso) so that I get 480i output, which is what I want, as I'm running on a TV that supports up to 480i.
The issue I'm having is that when using the In Game Reset (IGR.dol on the SD2SP2) when I reset back to SWISS (R+Z+B+DOWN or Z+A+Start) it always resets back to 50hz and doesn't seem to honor/load the settings I configured. If I power cycle the Gamecube, SWISS loads the settings as you would expect.
I believe the only two video related changes I made where to set "SWISS Video Mode" to 480i and "Force Video" to 480i
I'm running SWISS version 1318. I don't know if there is a newer IGR, but the one I have is probably a couple years old.
If anyone has any suggestions, please let me know!
Cheers!