SD-load issues...

[R3dfaction]

I burnt an iso with SD-Load and it runs the program but it does not load any dol's (or rather read them) on my Sd card via Wiikey Adapter. Is there something I'm doing wrong? I was also mentioned by emu_kidid to embed SD-Load it within the Cobra BIOS but I'm not unsure on how to accomplish that.

I have my dols on the root of the Sd cards (Tried with 2gb SD and 8 Gb Micro SD) and it just shows a blue bar. Any help would be appreciated...

[emu_kidid]

Firstly, SDLoad won't work with SDHC cards (4GB and over in size basically) as well as some microSD cards, even if they're under 4GB sometimes.

If you're using the SlotA & B version of the DOL, make sure you've plugged the adapter into the correct slot (If you don't press A on startup, it's slot A, otherwise it's slot B).

Finally, make sure the contacts are clean on the wiikey SD adapter as they can be quite tempramental if they have even a spec of dust.

Hope this helps!

[R3dfaction]

Tried both slots with the 2gb SD Card and still shows a blue line across, anything else I press ends up in a code dump, any other suggestions? Would embedding SD-Load in the BIOS make a difference (even I doubt it)?

[emu_kidid]

Ah.. you need FAT16! how could I forget :p

[R3dfaction]

Its in FAT so thats the probable cause, will attempt tommorrow thanks for the tip. Btw can you tell how to embed SD-Load on the Cobra Bios?

:L

[emu_kidid]

Since you have a viperGC Extreme, just flash the .DOL onto the 2MB flash.

[R3dfaction]

???

Since you have a viperGC Extreme, just flash the .DOL onto the 2MB flash.

I'm kind of a Noob, can you tell me step by step on how to do it? also I can't find an SD-Load.dol I only found the ISO, can someone upload it in the repository?

[R3dfaction]

bump... anyone???

[emu_kidid]

I can respond properly in a few days when I've got some time.

[R3dfaction]

Ok I've tried formatting my 2gb SD to FAT and it still shows a blue bar screen, please can someone help me? Is my SD Gecko defective?