i just received my xeno gc (or "xen8 gc" as the board says topside) soldered it on, runs the normal disks fine still starts red, blinks red once, and goes back to continuous red.
So i decided to try to unsolder it to connect it by wire, but cant unsolder it,( i think my irontip is too big) cant heat it and get the sucker on it. well in all my trying, i noticed i shoved this black thing over next to the P line and then i tried to shove it back----
![Image](http://ldktechnik.files.wordpress.com/2010/07/xeno21.jpg)
and now i really dont know what im doing or how to fix
my chip--
![Image](https://s15.postimg.org/togh48w23/20161208_042458.jpg)
and my irons tip
![Image](https://s15.postimg.org/or2wj4u2z/20161208_042603.jpg)
![Image](https://s15.postimg.org/4xqsqfgp7/20161208_042607.jpg)
edit- still lights up red in the same way, still plays the norm us disks, starting+holding down START gives me a bunch of lines scrolling down my tv (this was not tested initially)