Xenochip booting backups

ViperGC/Qoob/etc
Post Reply
Nelis
Posts: 2
Joined: Fri Dec 23, 2016 1:51 pm

Xenochip booting backups

Post by Nelis » Mon Jan 02, 2017 2:29 pm

Hello,

Recently i modded my gamecube with a Xenochip.
I adjust the laser to 25 ohm when it was reading verbatim discs.
Everything was fine for two days, but now just suddenly it wont reading backups again.
It will get the disc error when booting up the game.
I adjusted the laser even lower but it wont help anymore.
What should be the problem here?
User avatar
Streetwalker
Posts: 1736
Joined: Mon Dec 30, 2013 7:50 am
Location: Israel

Re: Xenochip booting backups

Post by Streetwalker » Mon Jan 02, 2017 8:19 pm

Most likely your laser is dead, buy a new one.
User avatar
emu_kidid
Site Admin
Posts: 4575
Joined: Mon Mar 29, 2010 10:06 am
Location: Australia
Contact:

Re: Xenochip booting backups

Post by emu_kidid » Wed Jan 04, 2017 2:25 am

Insert an original game into the GameCube and hold down the start button on controller 1 until the game should've started. If something other than the game comes up then the chip is fine and your laser is unable to read backups, if the game starts then your soldering wasn't a total success and something has probably come loose.
Image
Nelis
Posts: 2
Joined: Fri Dec 23, 2016 1:51 pm

Re: Xenochip booting backups

Post by Nelis » Wed Jan 04, 2017 11:54 pm

The chip is good installed because backups did run in the past.
And yes when i press start the xeno shell 1.5 apears.
I orded a new laser, gona try that.
Thanks
Post Reply