gc-forever - Gamecube/Wii Forums

Hey Everyone,

I have a Qoob Pro installed on a DOL-001B. Its has hacked bios hw0 sw1.3c. I had a version of swiss written to the flash memory that worked really well.

I just recently erased that unknown version from the chip and flashed Swiss r382 compressed dol to it. I launch the dol from the Qoob Pro menu and then it gets stuck on "running dol."

I have flashed other dols like SDload and mGBA to see if it was just the current Swiss or all dols. None load properly. I have erased and reflashed the bios and backgrounds with no issues. I have no idea what is going on.

I have been flashing with the cracked flash tool on a Win7 run in Win7 mode and WinXP compability mode. Any ideas or insight would be greatly appreciated.

That's a known issue with dolxz, put the uncompressed dol through dollz instead and flash that to your Qoob.

That said it's weird that other DOLs don't work, I'll put a simple one together for you to test.

Thanks Streetwalker. Swiss 0.4 r382 loaded properly after compressing it with Dollz. Swiss worked without a hitch and all is well in the universe again. Thanks!

Great, have fun.

Streetwalker wrote:That's a known issue with dolxz, put the uncompressed dol through dollz instead and flash that to your Qoob.

That said it's weird that other DOLs don't work, I'll put a simple one together for you to test.

Thanks Streetwalker this helped me out and saved me allot of time!

You should flash iplboot to your Qoob instead of launching Swiss as an add-on from the original bios. That way you can have it auto boot from your SD card.