WASP Custom from BAC seemingly non-working

ViperGC/Qoob/etc
Post Reply
ReWrite
Posts: 2
Joined: Fri Nov 02, 2018 4:27 pm

WASP Custom from BAC seemingly non-working

Post by ReWrite » Fri Nov 02, 2018 4:38 pm

Hopefully someone here can tell me that I'm the issue and the item is fine!

I bought a WASP back in July, got it in September, tried to install it two weekends back. It does not seem to work. It just boots up to the "An error has occurred. Turn the Power Off and check the Nintendo GameCube Instruction Booklet for further instructions." screen. My gamecube works fine when I replace the original disc drive, and back to the error screen when I put the WASP back in.

I've tried half a dozen different brands of SD card, all formatted properly in FAT32, ranging in sizes from 4GB to 64GB. I've tried each of the four dipswitch settings found in the wiki and they make no difference it seems. I have a US Gamecube with the digital out port.
ReWrite
Posts: 2
Joined: Fri Nov 02, 2018 4:27 pm

Re: WASP Custom from BAC seemingly non-working

Post by ReWrite » Wed Jan 09, 2019 6:29 pm

Managed to get hold of another, already modded Gamecube to try and re-flash the firmware on the WASP.

This is the screen i get after loading the FZN file from an SD gecko while the WASP is installed https://imgur.com/a/LPn962Y

The red LED is solid on the device, and the gamecube goes unresponsive. I've left it on for over an hour, so I'm positive it's not just me being impatient.

When selecting the WiiKey Fusion option instead of the SD Gecko it says "No SD card inserted" even if there is, and the red LED on the device goes out after it checks for SD card. I've tried a dozen or so different cards, tried exFAT and FAT32. All of them work in the SD Gecko, but not in the WASP it seems (which may be because it needs the FW re-flashed).
Post Reply