Xeno Modchip Problems
Posted: Tue Sep 22, 2020 9:10 pm
So I attempted to mod my gc today using the xeno modchip, I mounted the chip directly on the board but I only saw a constant red light, so i retried one more time and then decided to use wires instead but still not working.. after fucking around with my multimeter for 2 hours and doublechecking every connection and looking for bridges i found that one of the pins of the atmega ic of the modchip wasnt connected to its pad.... But after fixing it i still see only red light. The chip for some reason also has two red LEDs which makes it hard to get any info on whats happening. Holding start while starting the gamecube also has no effect. I have read in some posts that some chips arrive without beeing flashed, would I be seeing a constant red light in that case?
Im also scared that i grilled the chip in my numerous attemts, any way to check if its still funktional?
Im confident that its properly connected and that there are no bridges and i am very sad please help
Im also scared that i grilled the chip in my numerous attemts, any way to check if its still funktional?
Im confident that its properly connected and that there are no bridges and i am very sad please help