Close look on WODE
Posted: Wed Jun 01, 2011 8:48 pm
Hey Guys,
Some of you know that my soldering iron died, so i have alot of spare time
OK, i just took my wode out of the wii, to put it in a gc later on.
On a close look at the host connecter it seems to me that not all pins are connected to a controller on the board.
Could somebody approve of this?
Not all pins are needed on the mainboard side?
If someone understands german better than my englisch, here you go:
Hallo Leute,
Wie ihr vll wisst hab ich meine Lötstation zerstört, uns somit viel zuviel zeit
OK, ich hab gerade meinen WODE aus der wii genommen da ich ihn später in den GC einbauen möchte.
Als ich mir den Anschluss vom Host Kabel näher angeschaut habe is mir aufgefallen dass nich alle Pins belegt sind.
Soll heißen es sind nicht alle Pins an die Kontakten der Contoller die auf der Platine sind geführt.
Kann dies jemand bestätigen?
Sind nicht alle Pins zur Mainboardseite hin benötigt?
thanks to liquitt for correction
Some of you know that my soldering iron died, so i have alot of spare time
OK, i just took my wode out of the wii, to put it in a gc later on.
On a close look at the host connecter it seems to me that not all pins are connected to a controller on the board.
Could somebody approve of this?
Not all pins are needed on the mainboard side?
If someone understands german better than my englisch, here you go:
Hallo Leute,
Wie ihr vll wisst hab ich meine Lötstation zerstört, uns somit viel zuviel zeit
OK, ich hab gerade meinen WODE aus der wii genommen da ich ihn später in den GC einbauen möchte.
Als ich mir den Anschluss vom Host Kabel näher angeschaut habe is mir aufgefallen dass nich alle Pins belegt sind.
Soll heißen es sind nicht alle Pins an die Kontakten der Contoller die auf der Platine sind geführt.
Kann dies jemand bestätigen?
Sind nicht alle Pins zur Mainboardseite hin benötigt?
thanks to liquitt for correction