Hello again! Right... I'm using a PAL GC with a viper chip. I boot Swiss 0.1 with a disc. If I try to load the IDE-EXI I can see all the files and even execute them (though nothing ever works. They appear to load fine but I get black screen). If from Swiss 0.1 boot 0.3 from sd gecko I am not able to see any files anymore from the IDE. I know that it detects the drive because if I go to the info it tells me that there is a 9GB drive in slot B. any suggestions? also this is off topic but is there a way to write Swiss 0.3 into the vipers memory (without burning another disc. Straight from the USB gecko to the viper chip).
Thanks
Strange issues using swiss 0.3
Strange issues using swiss 0.3
Last edited by DragonBoy on Wed Oct 03, 2012 12:04 am, edited 1 time in total.
Re: Strange issues using swiss 0.3
9GB might not be ATA LBA 48bit compliant, there are issues if the HDD is not. Try something newer or over 128GB.
Re: Strange issues using swiss 0.3
Thanks for the answer emi_kidid! I tried a bigger hard drive (250GB) and I had some success but also similar problems! The success I had was that I could run super mario sunshine (but not luigi's mansion) using swiss 0.1 but in swiss 0.3 I had the same problems! I couldn't see anything! Also I had to use the "compatible" option because the "Fast" wouldn't work!