Hey,
Was going to make a Xeno chip tomorrow and mod my new cube, but found out its the DOL-101.
Cannot find any pinout, or tutorials for where to solder to.
Can someone help me out? I was going to remove the heatsink, but don't want to waste thermal paste unless I know I can find out which pads or pins to solder to.
Even which pins and which chip would greatly help.
Thanks
Xeno Pinout Dol-101
Re: Xeno Pinout Dol-101
Why would you be removing heat-sink, when XenoGC is soldered to DVD-ROM's PCB, which is separated from mainboard PCB?
Re: Xeno Pinout Dol-101
I didnt want to (and I didnt), but I was looking for the same caps I saw in other peoples images and I had assumed they put it on the other side of the PCB.
Nothing I read said you put it on DVD drive PCB, guess I'll take another look. Still would be handy to have a proper pinout or schematic.
I had read that the DOL-101 got rid of a PCB that used to mount on the main board, I was thinking that to fit the components on the board they may have had to move some components to the other side.
Again, just lack of info on the DOL-101.
Edit: Thanks man found it right away.. Guess I was skipped through it all too fast, and assumed it was the version.
Nothing I read said you put it on DVD drive PCB, guess I'll take another look. Still would be handy to have a proper pinout or schematic.
I had read that the DOL-101 got rid of a PCB that used to mount on the main board, I was thinking that to fit the components on the board they may have had to move some components to the other side.
Again, just lack of info on the DOL-101.
Edit: Thanks man found it right away.. Guess I was skipped through it all too fast, and assumed it was the version.