gc-forever - Gamecube/Wii Forums

Well i have been looking all over the internet on how to boot a back up games in the gamecube without any chip and i learned that the SD Memory adapter its my best shot yet i cant get to start working on noe beause i dont have the mini Dvd to that comes with the adapter. So i want to make an adapter where i can find the disc or theres another way that only involves the use of th SD?
sorry my bad english i havent been able to practice my writing in a long time

read this
http://www.gc-forever.com/wiki/index.ph ... g_Homebrew

you should think about adding a chip...or make your own chip...http://www.gc-forever.com/wiki/index.ph ... noGC_Clone

ok i want to know if i can burn my own boot disc

The gc-forever wiki is your friend

yeah i readed http://www.gc-forever.com/wiki/index.ph ... ebrew_disc that thread but i still confused because i thnik i need a modchip to read the disck made in that thread i mean i will do my own SD memory card adapter so i need to know what i need to burn that disc and if it would work as if it was the original boot disc for the SD media launcher.

and how to use the SD media launcher

YouTube

This might come in handy: http://www.gc-forever.com/wiki/index.ph ... a_Launcher

My question i need the orginal SD Media launcher disc or i can made a copy of it?

You need the original if you don't have a way of booting "backups".

thanks that was the question then im screwed

i dont have the disc and im not able to obtain an original one also the chip its out of reach... and its more difficult to build and install

i have been reading a lot most of the material its a bit complex to me but im excited to try to make the chip. I have the source code that its avaible in this site so i have some questions.

1.- to program the chip i just need the hex file and to installit i the chip?
2.- after the installation of the chip im ready to load games from the SD Gecko ?
3.- After the installation of the chip if i burn a game in a mini dvd my gaamecube will read it?

1. in the wiki, find a hex that has been listed as working
then you need to properly set the fuses on the atmega
then solder it in...
all this info is detailed in the wiki, look for it and read it a few more times but so far it sounds like you got the basic understanding

2. you cannot load anything from sdgecko. you actually load a dvd, swiss, sdload.
this will provide you the ability to search and load a file on your sd

3. yes, you might need to adjust the pot. not sure if thats in the wiki, but its all over the web. google: gamecube pot setting and look at the youtube video