Page 1 of 1
Anyone ever pinout the high speed port?
Posted: Sun May 24, 2015 8:39 am
by ShockSlayer
More or less I'm going to connect a Gameboy Player to a trimmed gamecube and I was curious to know if anyone's ever pinned that out to other sections of the board. I'm assuming that there are a few traces that go to the ARAM at least, but it's been a long time since I've looked at anything like this, so. Figured I'd make a topic and check before I go find my old dead boards and pin everything out myself.
SS
Re: Anyone ever pinout the high speed port?
Posted: Tue May 26, 2015 5:18 pm
by ShockSlayer
This is what I've got so far:
It's hard for me to figure out where things are going on the bottom side of the board because the image I'm using is pretty bad. I need better scans or my hands on a dead board I can play with, somehow I managed to lose track of all my lovely deadcubes.
Also, what's the deal with pin 34 (INT)? It looks like it's running off somewhere else on the board. Any relation to INT from the memory cards?
SS
Re: Anyone ever pinout the high speed port?
Posted: Tue May 26, 2015 8:50 pm
by megalomaniac
That should be enough pinout to determine not to trim...unless you really want to rewire the whole thing...??
Re: Anyone ever pinout the high speed port?
Posted: Tue May 26, 2015 9:04 pm
by ShockSlayer
I mean I don't inherently want to, but for things to fit the case properly I have no choice. Plus the one working cube I have already has the port removed, so I'm out of options on that front. I'm only missing about 15 pins from the diagram, I'm hoping they also go to the ARAM but I can't be sure yet. I might be able to glean a bit more info from these pictures but I'm not ready to dive back into it yet.