gc-forever - Gamecube/Wii Forums

Sorry for my english...
I made the install, check all pins with a multimeter and its ok (one point of each side of board...)
When i power on, the blue ligth blink, turn off and the gc show the error message...
Can someone help me?

Well, problem solved and another problem comes.
I solved the problem switch the pin number 1 to on.
When it boot SWISS it said something like "switch pin 3 and 4 to correct region" but if i do that, did not boot anymore.
So ok, i let only the pin 1.
Well, Swiss boot but i've tried to load games and received "disc does not contain valid word at 0x1c"
So i've tried to open another version of swiss.dol and did not open the dol.
So i've tried to flash the new version of swiss...
after the flash, do not work anymore, i power up and give disc read error....

megalomaniac wrote:http://www.gc-forever.com/wiki/index.ph ... ASP_Fusion

Thanks mega, but this is not the problem anymore...
After update Swiss version, it wont work anymore...
power on and give disc read error...
maybe i do the wrong process...
I've power on and execute swiss(ntsc).fzn
after finished the process, won't boot swiss anymore...
maybe i brick?

gcpro wrote: I've power on and execute swiss(ntsc).fzn

what is the exact name of the file you flashed?

megalomaniac wrote:

gcpro wrote: I've power on and execute swiss(ntsc).fzn

what is the exact name of the file you flashed?

swiss_r296(ntsc).fzn

you should not have had any issues with flashing...
try a 1.2 restore to see if it will recognize the SD card...

megalomaniac wrote:you should not have had any issues with flashing...
try a 1.2 restore to see if it will recognize the SD card...

already tried, not work =\
oh and when i flash i see some message like "firmware not found" (i think)

how did you create the 1.2 restore iso?
did you use DD or some other method?

megalomaniac wrote:how did you create the 1.2 restore iso?
did you use DD or some other method?

Win32 disk imager...
I'll try via DD and post my results...
Thanks mega...