Page 1 of 1
XenoGC POT adjust HELP
Posted: Sat Jul 11, 2015 6:33 am
by Nadestorms
Okay guys so I put a XenoGC in my cube a few months ago. And it worked fine with ritada ritek disks burning ISOs with imgburn. So after a while the burnt disks quit working (spin then stop) and only originals worked. So with a multimeter I adjusted it to first 200 then anywhere from 150-250 and i noticed it didn't ever work how ever toward the lower resistances it'd spin longer and longer. I tried setting it all the way down and it got so close to working but I can't go lower than like 20 without it jumping to 990. Help. Please. I have tried a new computer and new burn, no bueno.
Re: XenoGC POT adjust HELP
Posted: Sat Jul 11, 2015 12:21 pm
by Andross89
Hi,
When I used the XenoGC I got good results with DVD-R CMC MAG AM3 at top speed recording and Incremental mode in ImgBurn. Here in Brazil, I found this DVD-Rs with the PHILIPS and sometimes LG and MAXPRINT. I hope this helps.
Re: XenoGC POT adjust HELP
Posted: Sun Jul 12, 2015 12:24 am
by emu_kidid
CMC Mag discs are very bad in comparison to riteks. The GameCube will really struggle with them
Re: XenoGC POT adjust HELP
Posted: Sun Jul 12, 2015 11:57 am
by Andross89
I also only used RITEK until I recorded Pikmin 2. I had already recorded more than 50 games but I could not pass the logo of Nintendo with Pikmin 2. I bought from different shops and nothing ... until I found this brand manufacturer . This also solved the random DREs I had with RE 2 in a specific room. I gave these dvds to a friend and still works. And I recorded in 2008/09. I consider bad: Elgin, Multilaser and TDK.