Page 1 of 1

Qoob PRO & Qoob SX IN STOCK!

Posted: Fri May 06, 2011 2:26 pm
by emu_kidid
I have purchased possibly the last lot of Qoob PRO and Qoob SX's available from the manufacturer
and they're currently on sale in our Online Store!

Be sure to not miss out, because once they're sold out, they're sold out for good!

$6 Shipping world-wide for as many as you buy!

Image

Re: Qoob PRO & Qoob SX IN STOCK!

Posted: Sat May 07, 2011 2:49 pm
by Burbruee
Is it hard to replace an already installed ViperGC with a Qoob Pro? Also how many do you have of each?

Re: Qoob PRO & Qoob SX IN STOCK!

Posted: Sat May 07, 2011 4:18 pm
by infact
@Burbruee: Well, not difficult at all, you have to desolder the old wires and solder the new ones though.

See attached jpg.
qoob_viper_diff.jpg
(127.02 KiB) Not downloaded yet

Re: Qoob PRO & Qoob SX IN STOCK!

Posted: Sat May 07, 2011 8:02 pm
by liquitt
speaking of that, is there an alternative for the 5V soldering point nearby? that one's a bi*** ;)

Re: Qoob PRO & Qoob SX IN STOCK!

Posted: Sat May 07, 2011 8:52 pm
by infact
You can get 5v anywhere you want... ;-) When not sure, use the pin from the power board (see Ashen's pictures in this thread).

more info about the qoob 5v soldering point:
seen here: http://wiki.nintendo-scene.com/Qoob_Pro

When soldering the 5v wire for the Qoob Pro the gold soldering point might not accept solder without cleaning it first. First put some solder on the end of your iron then try to stick it to the point, but if after 2 seconds it wont stick remove the iron. Next clean the point using some sandpaper or a SOS pad (virgin pad w/o chemicals). Use a small brush or Q-Tip and apply some alcohol to the point. Next apply some flux to the point and then apply the solder. Make sure to only leave the iron on the point for no more then 3 seconds otherwise you risk heating up the board to the point where the resistor above the 5v pad will come off.

Re: Qoob PRO & Qoob SX IN STOCK!

Posted: Sun May 08, 2011 1:07 am
by emu_kidid
Burbruee, I have bought quite a few, but they are selling faster than I expected.. might sell out as fast as the IDE-EXI's did at this rate.

Re: Qoob PRO & Qoob SX IN STOCK!

Posted: Sun May 08, 2011 1:28 am
by infact
cause they are cheeeaaap ;-)

Re: Qoob PRO & Qoob SX IN STOCK!

Posted: Sun May 08, 2011 4:29 pm
by liquitt
infact wrote:You can get 5v anywhere you want... ;-) When not sure, use the pin from the power board (see Ashen's pictures in this thread).
i was thinking about using that one. question is, if the original cable is long enough, thats why i was asking for an alternative nearby...but i could still extend it....

Re: Qoob PRO & Qoob SX IN STOCK!

Posted: Sun May 15, 2011 5:23 pm
by JPnintendo
Hey, I have that chip and I know all about it. I made a tutorial about hot to use it. But in spanish and in other forum... I ll translate it, for thuse that will buy the device. (Yes... I have qoob... but my GC hasn“t DVD-Drive :( I NEED ONE! )

Re: Qoob PRO & Qoob SX IN STOCK!

Posted: Sun May 15, 2011 5:33 pm
by infact
Then get one ;-)

They are also in the online store for example.

Re: Qoob PRO & Qoob SX IN STOCK!

Posted: Sun May 15, 2011 10:45 pm
by JPnintendo
The problem is that I need a Complete Drive (that black thing than is inside) and here in Argentina is imposible to found one, and the GC`s than I see around here are chiped whit xeno :(

Re: Qoob PRO & Qoob SX IN STOCK!

Posted: Mon May 16, 2011 4:32 am
by liquitt
PM'd you ;)

Re: Qoob PRO & Qoob SX IN STOCK!

Posted: Fri Oct 21, 2011 2:21 pm
by MixMasterMike
Hi, I also bought a Qoob SX on the online shop, but since paying for it, I got no response whatsoever. Is this still a working shop and a trustworthy seller?

Re: Qoob PRO & Qoob SX IN STOCK!

Posted: Fri Oct 21, 2011 4:45 pm
by emu_kidid
I send all items out 1-3 days after the order is submitted. Orders all ship from Australia so postage times may be sluggish at best. Usual postage time is 5 to 14 working days (as most people have told me), some extreme cases are 20 days and super extreme (only happens to Canada) is 40 days!

Rest assured your item is on the way.

Re: Qoob PRO & Qoob SX IN STOCK!

Posted: Mon Oct 24, 2011 12:15 am
by MixMasterMike
Okay thanks, do you have some kind of tracking number so I can check on it online?

Re: Qoob PRO & Qoob SX IN STOCK!

Posted: Mon Oct 24, 2011 12:40 am
by emu_kidid
Sorry, no tracking numbers are used since here they cost about 2 times more than posting the item itself. I have not had any items go missing yet and I've sent about 300+ since the web store opened.

Re: Qoob PRO & Qoob SX IN STOCK!

Posted: Fri Oct 28, 2011 4:51 pm
by MixMasterMike
Ok my qoob arrived today, thanks!