Controller port 1 not working.

[XpertXP]

Controller port 1 will not register any commands on the screen in gameplay or in the menus. With a Wavebird connected, when I press the controller buttons, it registers on the dongle that they are being pressed (the dongle illuminates), that would mean the port is getting power I would assume.

Ports 2-4 work fine.

I have replaced the controller board with a known good working one and port 1 still will not work. This would lead me to believe the issue lies on the gamecube motherboard. Anyone have any experience in this? Or know where to start looking on the gamecube motherboard to correct this problem?

Thanks!

[boredomca]

Controller Port one is the most used. It's possible that the connection on the dongle is a bit worn and not making a proper connection with the worn first port. I would test with another controller, if it works fine then it's the dongle and would only require reshaping the pins

[XpertXP]

Controller Port one is the most used. It's possible that the connection on the dongle is a bit worn and not making a proper connection with the worn first port. I would test with another controller, if it works fine then it's the dongle and would only require reshaping the pins

I already tested it with a known good working controller board, and the same thing happened, also tested with 3 different controllers.

[boredomca]

Can you upload pictures of the mobo

[XpertXP]

Can you upload pictures of the mobo

Yes, I will do so either later tonite or tomorrow. Im at work currently

Thanks for the help!

[Extrems]

You forgot to mention something important.

https://assemblergames.com/threads/game ... ing.68998/

The issue is likely with GCVideo DVI's controller tap.

[XpertXP]

You forgot to mention something important.

https://assemblergames.com/threads/game ... ing.68998/

The issue is likely with GCVideo DVI's controller tap.

Yes, you are absolutely right. I forgot to mention that, sorry! Im going to use the alternate Controller connection as mentioned in the diagrams that are right above the controller ports. Im sure that will solve the issue.

Thanks again!

[XpertXP]

I have resolved the issue. Pin 94 from the Pluto board going to the GC motherboard was not making a good connection. Used the alternate solder point on the GC motherboard and the issue has been resolved.

Thanks again for the support.

Thread may be closed.