Page 2 of 2
Re: Power Source
Posted: Sat Oct 29, 2011 7:37 am
by Benni
Can you make a picture on which we can see where the wires are connected?
Thank You
Re: Power Source
Posted: Sat Oct 29, 2011 9:50 am
by yamaharacer
you only have to connect the wires to these points. red wire is 5V, yellow is 12V and the black ones are ground.
Re: Power Source
Posted: Sat Oct 29, 2011 8:31 pm
by Benni
SURE?
The Picture looks different!
12V is red
5V is Orange
...
OH, my mistake...
You are talking about the wires...
I found this one:
http://kyorune.com/modding/article.php?id=16
They say 12V is bridging Pin 19 and 21!?
Re: Power Source
Posted: Fri May 18, 2012 5:59 pm
by Burbruee
I'm interested in doing this mod, right now I always have to keep my gamecube right next to my PC which is not optimal.. Is yamaharacer's picture correct?
Re: Power Source
Posted: Sat May 19, 2012 12:03 am
by Burbruee
Re: Power Source
Posted: Sat May 19, 2012 12:11 am
by SouLSLayeR
Hey, it looks nice!
I'll probably go with this after I get my IDE-EXI working.
Re: Power Source
Posted: Wed May 22, 2013 11:41 pm
by RGB_Gamer
I know this is an old topic, but what about a power supply for a 2.5" HDD. Or what about a compact flash to IDE adapter
Re: Power Source
Posted: Thu May 23, 2013 12:00 am
by megalomaniac
just connect the proper power adapter...
2.5" and CF consume less power than some 3.5" HDDs...so its ok to still use GC power supply
Re: Power Source
Posted: Sat Aug 17, 2013 12:38 pm
by GameCube2
i am wondering if my IDE to sata adapter would work for this.
Re: Power Source
Posted: Sat Aug 17, 2013 7:03 pm
by megalomaniac
a lot of sata adapters have been tested and worked fine
here is a post from years ago with a lot of great results...i also own some of the adapters listed in the post and the adapters can usually be found for 2$ on ebay
