gc-forever - Gamecube/Wii Forums

i got a box load of amtel eeprom chips and iv been dieing to make a modchip out of one with the ability to be flashed from the gc i have action replay sd loader but idk how long the disk will last.

i was reading tmbinc`s info but i saw a pic with him having a eeprom just like the below chip accept different maker wired to the gc`s rom chip my problem is i need pinout bad like a conversion so i know where to put what... as eeprom pinouts are a bit diffrent.

my plan was to flash it with gcos or swiss.


(EDIT:> basicly just post as much as you can on tmbinc`s mod so i get a good picture of what is needed and what can be used etc Anything!.)

The fastest method would be to use the available XenoGC code to make your own modchip.

Only drawback, the chip you propose is not compatible since the released XenoGC code was compiled for the Atmega8 series and cannot be cross-compiled at this time...This means no current possibility to use any types of chips other than Atmega8 series...Yet, this would still be your fastest option if you want to continue your homemade project.

well i wasn't going for a drive chip at all...

here are the pics of what im trying to achieve.


my problem is i need to figure out where i would convert or connect these to an eeprom.

all info from below link.

http://x226.org/gc/gcold.html

pics have all the stuff i need but i cant figure out pinouts.... for the seriel in and out to eeprom. also vss clk etc... (all below pics and stuff.)
(and sadly i cant get a modchip for my gc as i cant buy stuff online so unless i find a free one to be donated then i will have to figure out tmbincs method used in ninja mod chip.)

how much progress have you made on this project?

have you successfully compiled the source?
do you have a xilinx chip?
you only want the ability to add an epprom to the existing xilinx chip?

i think you're just referring to a photo made while this was in development, his final board looked different and had more stuff on it than just the xilinx. i can photograph mine if you want

sure that would help


also on that i cant find any of his final stuff only dead links.....

have ypu tried using the wayback machine?

liquitt wrote:have ypu tried using the wayback machine?

basicly i was asking if everyone can throw all there info of tmbincs mod here so i have enough to make one up from scratch.

well, tmbinc had everything you need up on his website, thats why i was asking if you tried wayback machine

liquitt wrote:well, tmbinc had everything you need up on his website, thats why i was asking if you tried wayback machine

tryed never found any pics or much info only him talking about triforce dump info.

MSaki wrote:

liquitt wrote:well, tmbinc had everything you need up on his website, thats why i was asking if you tried wayback machine

tryed never found any pics or much info only him talking about triforce dump info.

http://www.eurasia.nu/modules.php?name= ... ncs_gc_mod

way ahead of you.

is it even possible to re-flash the actual ipl chip? i know there is a way to clear it but not flash??

i mean besides that.

I wanted to do this stuff for a long time!
I believe I already made a thread on this, if I didn't I post the all stuff I got to this tomorow.