MFE Distro SD boot

[yamaharacer]

Hello,
i have got a problem. I searched the whole day on the internet how i can start mfe distro without burning a disk just by booting everything from the SD card. Then I have found several sides which linked me to tehskeen, but tehskeen is dead.
Al this sides said something about mortimor mfe distro. I have found this distro and tryed to run it on my cube but it doesnt work. It ends with an i/o error dev sdslotn or something and stops loading.

Does anybody know how I get this thing working?

[liquitt]

can you post a link to that website where you found it?

[yamaharacer]

no problem its a spanish site:
http://www.elotrolado.net/hilo_mfe-mort ... eto_475782

could it be that this software just loads of slota but when it boots it recognizes that the sd card is in slotb.

[yamaharacer]

ok I resoldered it on slota but it still doesnt work.
i have a viper gc extreme installed with that chip i start sdload. after that i load mortboot.dol. in the root of the sd card is the mfe-fs.bz2 data. but it still ends with the same error only with sdslota instead of sdslotb.

[liquitt]

no hablo espanol

sorry, can't help here, never tried the sd version of mfe. when i'll re-set up my whole gc enviroment i'll look into this!

[Aressi]

What is the kind of error you got?

Yo hablo español por si tu tambien y tienes dudas

[yamaharacer]

error message:

end_request: I/O error, dev sdcarda, sector 0

[emu_kidid]

error message:

end_request: I/O error, dev sdcarda, sector 0

If you're using a SDHC Card it's probably not going to work.

[liquitt]

thats what i was going to say, since this is a linux standard error...otherwise it might be the filesystem on the sdcard?

[yamaharacer]

i dont use a sdhc card. its a 2gb sandisk card I am using. I dont understand the problem.

[_ich_]

The File is down, can someone upload "mfe-mortimor-edition.tar.gz"?
Thanks