Swapping to SDHC after booting, files don't show up

[emu_kidid]

Start Swiss, remove all SDGecko/etc completely.
Go to the device menu, move the selection to SD
Press X, set speed to 16MHz (Slow)
Insert SDGecko/etc with SD card in it
Press A

What happens then?

[BenoitRen]

What about loading (and patching) a single DOL from a multi-DOL game disc, such as The Legend of Zelda: Ocarina of Time: Master Quest?

[emu_kidid]

Master Quest disc works here in its entirety from SDGecko (ok, maybe not the movies).

The problem with loading a specific in-game DOL directly is that it might rely on some other setup data/parameters to be passed to it that I wouldn't know about.

[MisterShmi]

Start Swiss, remove all SDGecko/etc completely.
Go to the device menu, move the selection to SD
Press X, set speed to 16MHz (Slow)
Insert SDGecko/etc with SD card in it
Press A

What happens then?

same thing. says reading SD in slot B and then after a while goes back to device selection.

[BenoitRen]

Master Quest disc works here in its entirety from SDGecko (ok, maybe not the movies).

Yes, but 480p won't survive the loading of a game.

Not like I can try anymore anyway, as the loader crashes due to the returning audio streaming bug.

[emu_kidid]

if you do it from SDGecko it does, the games have minimal lag since the bulk of it is loaded at the start anyway.

[BenoitRen]

Wait, what? Master Quest behaves differently when it's on a SD Gecko?

[emu_kidid]

I can write patches for SDGecko/IDE-EXI loaded multi-dol games, then those can be read in place of the original content, thus allowing multi-dol games to work with forced video modes/etc.