SD2SP2 Homebrew support?

[andre104623]

Hey everyone its been a while I was working on switch "projects" for the pass couple years but got around to soldering one of these new SP2 PCBs thank you 3000psi! But anyway I can't load any homebrew like snes, Nes, sega, N64, ISOs on the other hand work good like really good really fast like wiikey fusion fast which is a shame because I really wanted to test N64 games. Glad to see these new projects popping up I ordered some more stuff to test from OSHpark and now there doing flex PCB!. So if there is some version I need to be using can someone piont me in the right place I remember to get my IDE-EXI to work I had to use versions made for it speaking of which what happend to IDE-EXI V2 firmware last I heard it was almost done

[Extrems]

The latest version of all of those support the SD2SP2.

https://github.com/dborth/snes9xgx/releases
https://github.com/dborth/fceugx/releases
https://github.com/ekeeke/Genesis-Plus- ... ter/builds
https://github.com/extremscorner/not64/releases

Additionally, Not64 support the IDE-EXI.

[Papy.G]

I know the SD cards are slimmer and sufficient in speed and size nowadays, but just out of curiosity, is or will be IDE-EXI support extended to SP2, just in case someone wanted to build such an adapter?

Andre, while the 8-16bit era emuators are running very well on the Cube, don't put too high expectations on the N64 side.

[andre104623]

I have 3 ide-exi there so slow you will use it once and never used it again I have both versions emukidds and megas same issues

[andre104623]

To be honest I was really surprised at the development in 4 years I been gone I left right after gcvideo just came out and I made a few of them then took a break. I really can’t believe how fast sp2 is and gcloader also very cool. I’ve knew about hyperboot since 2014 surprised it’s taken so long to be announced and still not released

[Extrems]

It's not that much slower than SD2SP2, and there's room for optimization.